Maintenance of laser cutting machine-how to maintain and maintain laser cutting machine.
Update:Jan 30,2023
Summary:Maintenance of laser cutting machine-how to maintain and maintain laser cutting machine 1. Maintenance of laser cutting machine: Maintenance method of......
Maintenance of laser cutting machine-how to maintain and maintain laser cutting machine
1. Maintenance of laser cutting machine: Maintenance method of laser cutting machine. The maintenance of laser cutting machine is as follows: 1. The temperature control point of the water control tank should be appropriate, otherwise the laser tube will be damaged and dewed, and the power will drop. The cold water head falls off, the service life is greatly shortened, and sometimes it can't work, which leads to the constant replacement of pipes. 2. The mounting fulcrum of the laser tube of the laser cutting machine should be reasonable, and the fulcrum should be 1/4 of the total length of the laser tube, otherwise the spot pattern of the laser tube will deteriorate, and sometimes the spot will become several points in a period of time. 3, should always check and clean the waterproof protection device. Cooling water often fails to flush the protection float switch or the water protection float switch is not reset, so the short circuit method cannot be used to solve the problem. 4, should regularly check and clean the suction device, and clean the fan duct. Otherwise, a lot of smoke and dust can't be discharged, which will soon pollute the lens and laser tube, and lead to easy oxidation of mechanical and electronic components, leading to poor contact. 5. Check the focusing mirror and reflector. After working for a period of time, the lens frame will heat up and the surface of the lens will change color and rust; Due to the accumulation of water on the focusing lens, it is necessary to ensure the cleanliness and quality of the lens in the optical path system regularly. 6, the working environment of laser cutting machine should not be too bad. If the ambient temperature is higher than 30 degrees and lower than 18 degrees, there will be too much dust, serious air pollution, machine damage and rising failure rate; All kinds of electrical accessories are prone to problems in humid environment. 7. The power of the power grid should be matched. 8. The working current of the laser tube should be reasonable, and it cannot work at full power for a long time; Reasonable use of laser to save laser energy; The optical path system should be cleaned regularly, otherwise the laser tube will be prematurely aged and broken, the power should be adjusted to 50-60% of the total power, and then the working speed should be adjusted according to the material to make the laser tube in the best working state.
English
简体中文
France
España
العربية
